Trailer for Roll-Off Containers

Fliegl ZPS 180-AS Maxi Schlitten für Abroller

Customized transport solution
Configure your Fliegl vehicle according to your requirements. The vehicle shown is an example only. Production and equipment are customized according to customer specifications.

# Chassis – Turntable Container Trailer

Heavy-duty fine-grain steel welded construction

Sliding container system:
Container is loaded from the rear onto the sliding frame and pushed forward. Adjustable front container stop for 6.0 m, 6.5 m and 7.0 m roll-off containers with external rollers.

Container locking system:

* 2 pairs of recessed locking hooks
* Pneumatic operation

Heavy-duty turntable with ball-bearing ring.

2 wheel chocks with holders
Aluminium side underrun protection
Steel rear underrun protection
Half-shell mudguards
Vertical rear impact protection (left and right) with Delta rubber buffers
1 spare wheel holder with mounting kit
Lockable plastic toolbox with drawer and shelf (650 × 520 × 670 mm)

# Drawbar

Drawbar with certified 40 mm towing eye

# Axles + Suspension

SAF disc brake axles
Laser-measured axle/chassis alignment for reduced tyre wear and fuel consumption
Air suspension with raise/lower valve

# Wheels and Tyres

385/55 R22.5 tyres on factory silver steel rims

# Brake System

Dual-line compressed air braking system
Spring parking brake
Drive-away protection: parking brake is automatically activated when the container locking system is open
Vehicle Stability System (VSS)
2 non-interchangeable air couplings with connecting lines to the towing vehicle
Electronic Braking System (EBS) with front connector and connecting cable

Note: Trailer may only be operated with towing vehicles that ensure full ABS functionality.

# Electrical System

24 V electrical system
Multi-chamber lighting
Yellow LED side marker lights
2 white front position lights
Bsdjzna Tdjpfx Amasww
2 white/red rear outline marker lights
2 LED rear work lights, activated via reverse gear
2 × 7-pin front connectors with connecting cable

# Registration

Prepared for registration in Germany
DEKRA approval and certificate according to §13 EC-FGV
24/7 service hotline
Prepared for single-line number plate holder
ECE R48 reflective contour markings (white sides, red rear)

# Finish

Frame hot-dip galvanized with passivation or painted in customer's preferred colour
Drawbar KTL-coated in black